Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-23-2003, 08:20 PM
|
#2 |
|
Registered Member
Join Date: Jan 2003
Posts: 66
|
i think you're talking about the harmonic balancer, has hash marks on it, used for timing the engine, etc.,.... well, you can remove it with a slide hammer,,...you screw in some bolts into the threads for the pulley and you pull on those bolts (ie with a slide hammer) to pull the balancer off the crank.
__________________
66 coupe: 351W 30 over. Fiberglass shelby parts + flares |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pully install problem | CaliJ1 | Modular Madness | 14 | 07-31-2003 12:34 AM |
| alternator pulley to crank pully ratio | redrider | Windsor Power | 0 | 12-18-2002 11:43 AM |
| March ram air and pully kit | 91PA5liter | Windsor Power | 4 | 06-03-2002 07:35 PM |
| Steeda pully install = oil leak?!! | Rally | Modular Madness | 7 | 04-05-2002 02:58 PM |
| pully sizes 5.0 | greydan | Windsor Power | 3 | 12-14-2001 01:27 AM |