Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-26-2003, 11:07 PM
|
#3 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Those are mine, I was pkaying with the colors. And funny you should ask frr a night shot, cause I just got the wiring settled (for the most part anyway) and here you go:
 The green didnt look that good at night either. I liked the concept, but the final result was not that great. I like the orange also. The red looked good, but it was kinda dark, and everyone I talked to is doing the red. Keep in mind that digital cameras take all the light that they can and utilize it. The speedo lights are not that great. Mainly because there is a section on the frame of the gauge that is like a checkerboard type of thing.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn: PKRWUD: Compression Test Results | 95mustanggt | Windsor Power | 13 | 06-22-2004 07:34 AM |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| Performer RPM | -RootS- | Windsor Power | 4 | 04-25-2003 06:24 PM |
| Vacuum reading at idle? | exgmguy | Windsor Power | 20 | 09-27-2002 06:22 AM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |