Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-28-2003, 07:23 PM
|
#18 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
Stubborn bolt?
I had all manner of hell trying to get that bolt out of my 4Runner v-6 when I was replacing the timing belt. I tried an impact wrench with no luck and almost everything else I could think of. The way I finally got it out was to put a box end wrench on it and beat the wrench about 6 inches from the bolt with a big ball pean hammer until the bolt finally came loose. Worked for me.
Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pully install problem | CaliJ1 | Modular Madness | 14 | 07-31-2003 12:34 AM |
| alternator pulley to crank pully ratio | redrider | Windsor Power | 0 | 12-18-2002 11:43 AM |
| March ram air and pully kit | 91PA5liter | Windsor Power | 4 | 06-03-2002 07:35 PM |
| Steeda pully install = oil leak?!! | Rally | Modular Madness | 7 | 04-05-2002 02:58 PM |
| pully sizes 5.0 | greydan | Windsor Power | 3 | 12-14-2001 01:27 AM |