Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-28-2003, 10:02 PM
|
#6 |
|
Registered Member
Join Date: Sep 2002
Location: IL
Posts: 105
|
Yea i want to lower the compression of the pistons, by using a bigger CC they are 12:1 on 54cc heads so i wanted to drop it to 11:1 or less by using 63 or 64 CC heads, and my cam would work well with these heads also but i dont want to lose any low end tourqe what kind of heads or setup should i use, because i have stock 2:73s in the rear but i like the top end they have i hit 170 in fourth i didnt take it to fifth, but i have the roush 200 heads in mind but im open to suggestions! I have high end parts in this car and it sucks that it dosent work! Any one hae anymore comments or suggestions?
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New FRP Heads for 96 - 98 4.6 | surfbeast | Modular Madness | 9 | 11-21-2002 07:02 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Performance from Cast Iron Heads | diablopony | Classic Mustangs | 7 | 02-20-2001 07:47 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |