Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-29-2003, 08:24 AM
|
#7 |
|
gear banger
Join Date: Aug 2000
Location: CHICAGO
Posts: 1,144
|
You have to ditch the gears man. The only reason I could see keeping them would be if you had over 450ci of big block torque, or a positive displacement blower on your smallblock. Even then 2.73's will still hold you back.
Get some 3.73's or 4.10's and it will wake your car up big time! If you still are not happy I would go with Trick flows for heads with a good breathing meidum runner intake. With your cam the 2.02 valve may cause clearence problems with the World heads but I'm not sure what kind of notches you have in your pistons.. The trick flows may give you enough room without notching them. Gears! Gears! Gears!
__________________
79 Hatch: NA 347, Stage 2 Canfield Heads, Victor JR. Intake, Blueprinted Holley 750 HP, Solid Roller Cam, Shooting for 10's on motor 93 LX: Tremec, dual friction clutch, fms flywheel, Hedman shorties, O/R H-pipe Ricer hater's club member #49 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New FRP Heads for 96 - 98 4.6 | surfbeast | Modular Madness | 9 | 11-21-2002 07:02 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Performance from Cast Iron Heads | diablopony | Classic Mustangs | 7 | 02-20-2001 07:47 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |