Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-21-2001, 01:56 AM
|
#2 |
|
Registered Member
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
|
Best thing to do is buy used.
Get some aluminum heads for about $600 Have the exhaust side ported a bit. Do a valve job and you should be in it for about $800 Get a cam, rockers,extrude honed intake(used...about $400...porting alone would cost that) 65 TB, 190 LPH fuel pump, 24 Lb. inj. With installation at about $500...this would put you about $2600 bucks...and get you an honest 280 HP. A 5-speed should go 12.30-12.50 w/ that combo. ------------------ '88 coupe...stock as a rock. Check out http://www.burnouts.stangnet.com 11's coming soon!!!! Heads,intake and cam are all here |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fastest Stock Motored 87-93 GT Mustang You've Seen | Mustang_GT_90 | Windsor Power | 18 | 07-07-2003 03:38 PM |
| AFR 165's or other heads with cam and stock induction | Mustang_GT_90 | Windsor Power | 27 | 11-25-2002 03:01 PM |
| 2k2 GT will not remain stock, suggestions? | Torinalth | Modular Madness | 8 | 05-15-2002 09:52 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |