Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-30-2003, 10:58 AM
|
#10 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
I think the C&L kit comes with a mass air meter, K&N, and heat shield. That's the route I would go and forget about changing the throttle body or getting a cold air intake.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can water get in your engine through a cold air intake? | NYC1 | Windsor Power | 10 | 04-20-2005 08:39 AM |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Cold Air Intake Discussion | King Snake | Modular Madness | 7 | 10-13-2000 04:37 PM |