Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-01-2003, 11:20 PM
|
#2 |
|
Registered Member
Join Date: Feb 1999
Location: Houston,TX
Posts: 466
|
With the 69 heads you are going to want a cam that favors the exhuast not a single pattern like yu have used for examples... How much are you polanning on spending? I would suggest converting to roller using the comp cams conversions rollers with a tie bar they will allow you to run any of the "new" roller grinds regardless of if it is a small base circle conversion cam or not. and for off teh shelf cams to price i would say the stage 2 oe 3 trick flow cam depending on how radical you are going to get with it.
__________________
A good plan, violently executed now, is better than a perfect plan next week. George S. Patton, General (1885-1945) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SN-92,SN-93,GSS Paxton Ball-Drive Guys Step INSIDE | Mustanguy | Windsor Power | 4 | 02-13-2006 12:13 PM |
| Here is the deal with the GM guys at work | bri32z | Stang Stories | 22 | 11-27-2001 01:34 PM |
| Help!! Need some Advice and pickmeups!! | SxyRedStang | Blue Oval Lounge | 13 | 10-23-2001 03:02 AM |
| dynoed my car guys! | 46stang | Blue Oval Lounge | 7 | 09-11-2001 09:08 AM |
| dynoed my car guys! | 46stang | Stang Stories | 3 | 09-08-2001 11:49 AM |