Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-02-2003, 08:12 PM
|
#1 |
|
Registered Member
Join Date: Jul 2002
Location: Michigan
Posts: 417
|
Well my bad, that kid was dumb and yes I also had the BBK pullies but i sent them back cause my bolts were rusted pretty bad even after i used some rust removal spray dont remember the brand but i had an airgun that hooks up to the air pump and it wasnt powerful enough to remove the bolts and i didnt wanna pay a shop to use there powerful gun so i got the bigger maf system insted.
__________________
1996 Mustang GT, AODE -Trickflow Upper Plenum -BBK 70mm Throttlebody -02 PI Lower Intake -March Pulleys -BBK H-Pipe -2 Chamber Flowmaster mufflers -3000 RPM Stall -JLT CAI with special K&N -MSD Supercondutor wires -180 stat -FRPP 4:10's *FOR SALE C&L TRUE FLOW INLET PIPE WITH K&N* My Stang |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Underdrive Pulleys | stangbanger3 | Modular Madness | 2 | 04-26-2004 12:11 PM |
| pulleys | strokerman | Classic Mustangs | 0 | 05-26-2002 07:23 PM |
| pulleys | strokerman | Classic Mustangs | 2 | 04-25-2002 09:11 PM |
| Supercharging...remove underdrive pulleys?? | quick89gt | Windsor Power | 4 | 04-03-2001 10:15 PM |
| ASP underdrive pulley's | Shotgun28 | Windsor Power | 2 | 01-15-2001 12:55 AM |