

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#10 |
Registered Member
Join Date: Aug 2002
Location: Rochester
Posts: 553
|
![]() I got code 67 after reseting the computer and running the car around the block hard and idleing and everything fully warmed up to its potential with that stat... I plan on getting rid of that stat this weekend. this is what i have done to my car. trickflow upper and lower, 65mm TB with spacer, F cam, 1.6 to 1 roller rockers, equal length headers, h-pipe, flows, msd coil, holley anihalator TFi module, #24 injectors with pro-m 75mm mass air, bbk 155lph fuel pump, k&n, A3M1 ECU, etc. i have thefuel set to 40lbs with vaccum off. maybe i should raise it to 45 but i heard guys with drivability problems.. but then again every car is different. could that stat cause my code 41 lean fuel constant?
|
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advance ignition timing on 1994 5.0?? | JChalfan | Windsor Power | 6 | 05-05-2009 12:35 AM |
ignition timing problems | MetalHead | Classic Mustangs | 7 | 03-21-2002 07:28 PM |
points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
Holley ignition, coil, and distributor installed..car won't start. Any ideas? | chadtn2 | Windsor Power | 5 | 08-13-2001 01:13 AM |
Ignition Timing and Vacume | jseaton | Windsor Power | 2 | 04-29-2001 11:06 AM |