

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
![]() Yes, I did check for fuel and spark. the TFI module was lighting a test light upon a ignition as was the injectors. The fuel is there also. Set it at 40. I'll tell my engine builder about the advice you all are giving me about the 180 out. Hopefully it will work. What about these sensors that are open on my pass. side. They are female connectors and one of the two actually matched identical to the driver side open sensor. These sensors I'm talking about are not for oil press. or temp or injectors, however they are on the harness. Also, I have a vacuum line coming from the gas tank that is pouring out fumes every time I tried to start the engine. What do I plug it into??
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Engine break in idle fluxuations-any ideas? | jim_howard_pdx | Windsor Power | 1 | 10-13-2002 03:28 PM |
Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
Engine Rebuild | rppngears | Windsor Power | 6 | 07-31-2002 01:29 PM |
My first Dyno run. | chris91LX | Windsor Power | 20 | 01-07-2002 10:03 PM |
Engine Shifting into radiator and also clucth broke | Stuffie0912 | Classic Mustangs | 2 | 12-03-2001 03:26 AM |