Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-05-2003, 12:28 AM
|
#1 |
|
Registered Member
Join Date: Apr 2000
Location: Edmonton,Alberta,Canada
Posts: 317
|
I use a Canadian tire formula 1 filter. Im assuming you would use the sandpaper to clean the contact where the wire goes to the sending unit. Sometimes the unit itself will start to read wrong. The only other possibility is if its only doing it when the engine is idling then you may really have low oil pressure and its just not reading much so it goes down to 0. What does it go to when you bring the rpms up. Usually you should check the oil pressure at about 2000 but it should never be below about 7psi
__________________
Fast Company |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Leaky power steering pressure line problem | Stang_ROTY | Windsor Power | 6 | 08-27-2004 09:24 AM |
| Autometer gauge problem - Always reads oil pressure... | 88COBRA | Windsor Power | 0 | 09-06-2001 06:44 PM |
| Surging Problem - Help | Lawless | Windsor Power | 32 | 08-19-2001 10:57 PM |
| Have oil pressure problem | 1SILLYGT | Windsor Power | 10 | 08-11-2001 12:50 AM |
| pressure problem | MastaNEEK | Windsor Power | 1 | 07-27-2001 07:32 AM |