Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-26-2001, 03:39 AM
|
#2 |
|
gear banger
Join Date: Aug 2000
Location: CHICAGO
Posts: 1,144
|
It's hard to say with out hearing it. Are you sure your valvetrain is adjusted right? Did you check piston to valve clearance? If you checked all the normal stuff and you still think it is the rotating assembly you can pull all the plugs and rockers then turn it over by hand. If you feel any little thumps or it gets stuck somthing is not right.
When I assembled my 347 the rod bolts would hit the girdle when I did the final check before putting on the oil pan. The girdle was for a 347 and allready had notches ground in it but it still was not enough. ------------------ NA 347 W/ stage 2 Canfield heads, out of the box Victor 5.0 intake, solid roller cam, Aeromotive fuel system. MY CAR http://www.mustangworks.com/cgi-bin/...splay.cgi?1288 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| Blown Stroker Computer Help | RabidPony | Modular Madness | 10 | 02-07-2004 11:56 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| 351w or 347 stroker? which is better? | BLACK85GT | Windsor Power | 55 | 12-21-2002 06:52 PM |
| stroker engine question | 82 GT | Windsor Power | 1 | 06-08-2001 03:22 PM |