
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#2 |
|
Registered Member
Join Date: Jul 1999
Location: New York State
Posts: 242
|
Just wondering...I see in your signature that you have a stang "all apart in the garage". Any chance it uses a carb that you could put on the LTD to see if your problem changes?
I don't have any other ideas except to call Edelbrock tech line. My friend had a stumble problem with his Edelbrock 750 that was causing a lot of grief. They told him to drill out a couple of passages to a bigger orifice and it fixed the problem. Good luck. The wagon sounds pretty cool.
__________________
Your basic carbed 302 with Edelbrock Performer heads, Performer RPM intake and 650 Speed Demon. My 1988 Mustang GT |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
