Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-21-2003, 07:43 PM
|
#5 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
A good cam will not cost you that much more. If your going to be pulling everything off for heads, then you might as well go ahead and get the cam. A good cam will cost you under $150.00. Just be sure to look at your durations so you don't get what you don't want.
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Victor Jr. manifold is in - have questions about breather cap on valve covers | Stang_ROTY | Windsor Power | 2 | 08-19-2004 09:39 PM |
| valve springs....questions | Old Guy with 87 GT | Windsor Power | 5 | 05-03-2002 06:36 AM |
| Valve train 'a knocken,oil pressure blues | robertwigton | Windsor Power | 4 | 12-04-2001 06:27 PM |
| DOHC Valve Train Noise | timbo3282 | Modular Madness | 0 | 08-29-2001 03:41 PM |
| valve train question??? | vande97 | Windsor Power | 0 | 05-04-2001 05:00 PM |