Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-25-2003, 04:52 PM
|
#3 |
|
Registered Member
Join Date: Jul 2002
Location: San Clemente CA.
Posts: 85
|
Wll its gonna take a bit more time than I got right now to get this toy in . I have to flip the linkage mount on my tranny so that it is pointing down NOT up like it does stock. I had the shifter in and hooked up i looked great, and sat in the perfect position for my hand, but alas when I tried to put it into gear I discovered that my stock shifter PUSHES the linkage whereas the B&M PULLS. oops. May be in a couple weeks Ill have more time to mess around with it... The thing that is holding me up now is how to pull the linkage off the tranny. Not the bar that connects to the shifter, but the arm that clamps onto the rod comming out of the tranny. there are no C-clips, or anything like that. any Ideas?
Mike
__________________
A great man once told me, "..." Well any way I guess that he wasn't that great. My garage: 1971 Mustang Grande, MSD6A, 625 Road Demon JR, Edelbrock Performer manifold, Hopes and Dreams... 1970 Norton 750 Commando 1993 Saturn SC2. The wifeys. fuzzy dice and all. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| B&M Ripper Shifter ? | 95/GT/5.0 | Windsor Power | 2 | 09-26-2003 01:52 PM |
| Anyone ever install a B&M hammer shifter in there AODE 4.6 GT?? | 96_4.6 | Modular Madness | 15 | 08-24-2003 12:43 AM |
| B&M ripper shifter? | stang_guy_95 | Windsor Power | 2 | 03-23-2003 11:43 PM |
| B&M Ripper vs. Kirban Kwik Shifter | DEPete | Special Production | 1 | 03-30-2002 08:10 PM |
| B&M Ripper vs. Kirban Kwik Shifter | DEPete | Modular Madness | 4 | 01-17-2002 12:20 PM |