Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-27-2003, 01:32 PM
|
#14 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Set up another bolt the same size somewhere else, and use your torque wrench on it. Then try to tighten it further with the ignition wrench, and pay attention to how much effort it takes you to get it to move. That's about how tight you have to tighten them.
 Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check Coolant light on when cold | Tecknowolf | Windsor Power | 2 | 09-14-2003 06:35 PM |
| Hard cold starting? | twilightcall | Windsor Power | 0 | 06-24-2003 06:44 AM |
| cold air intake | TRipSOber | Modular Madness | 13 | 05-01-2003 03:49 PM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| I cannot believe I forgot to ask about Cold Air intakes. | SlowStang2 | Windsor Power | 1 | 07-16-2001 06:26 PM |