Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-09-2003, 03:17 AM
|
#6 |
|
Registered Member
Join Date: Feb 2003
Location: Minturn, CO 81645
Posts: 109
|
just a couple of questions
Would it be easier to just replace the harness? SVO has a harness for 210 dollars. It might save problems later down the road.
I am trying use a strategy when going through the electrical problems. I thought I would try to go through the harness connector side of the ecm and make sure that all the wires match the pins they are suppose to go. For instance I received code 22, which is MAP/BP [BARO*] out of Self Test Range. I would go to the Map Sensor, which uses Pin wires 46, 45 and 26. I would find out what the color of the wires are and make sure they have good connections. Then I would make sure they are in their correct pin holes. I thought that I would check resistance also. I thought that I would post my results How do you feel about Dielectric grease? |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pulled codes...what do they mean? | Hethj7 | Windsor Power | 8 | 06-12-2003 12:03 PM |
| Pulled intake and swapped fuel rails now getting codes. | Rebel79 | Windsor Power | 3 | 09-03-2002 12:13 AM |
| pulled codes and could use some advice | Conman | Windsor Power | 9 | 08-17-2002 06:41 PM |
| Pulled codes today... | bobtodd | Windsor Power | 24 | 08-08-2002 07:55 PM |
| Pulled Codes from Car, Need Help! | StreetStang37 | Windsor Power | 11 | 09-24-2001 05:58 AM |