Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-09-2003, 04:36 AM
|
#1 |
|
Registered Member
Join Date: Oct 2002
Location: Fresno, CA
Posts: 101
|
You should port and polish the inside of the plenum now. I did that a few weeks a go to mine, it was pretty fun, dyno test show 4.9 HP and 11 torque if I remember right. I used my dremel, make sure that you get ride of the bead on the top side that is what gets ride of the turbulence, make sure you where a mask though, I didn't, and I was coughing up silver mucous for a few days. I think I will pull my plenum off a gain and polish the outside. That looks nice. MAybe I should do that to my procharger too.
__________________
 _________________________________ 04 Cobra densecharger CAI BBK off road X pipe Custom Electronic Exhaust cut outs Tuning via Diablo Predator Ported and polished Throttle body and plenum Line locker (for the smoke shows) Stock boost 412 rwhp 379 rwtq |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|