

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#5 |
Registered Member
Join Date: Jun 2003
Location: Bay Area, Ca
Posts: 86
|
![]() This is what I did, and was not dissapointed:
Gears: 3:73's should run you $350 installed Free flowing cat back: O/R H or X pipe(MACS are $119, plus cat back of your choice(MAC Cat Back is $299) K&N Filter charger Kit, do not get a CAI, just get the K&N kit that utilizes your stock air tube. $80 Pullies if you want, some guys say no due to charging problems, I say go for it, and don't swap out the alternator pulley. That leaves you with $150, you could possibly pick up some headers for that price. hope this helped. You will love the way your car feals after, trust me.
__________________
StAnGaHoLiC!!! 1995 GT S-Trimmed 306, with H/C/I, and some other stuff. It just sounds fast. My Car |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
What are some good factory heads? | Cameron | Windsor Power | 3 | 04-17-2004 01:44 AM |
Price estimate for barely used Edel. Perf. RPM alum. heads w/ 2.02/1.60 valves?? | Simi Stang | Windsor Power | 13 | 11-03-2003 11:23 PM |
351W heads on 289? | 66 Racer | Classic Mustangs | 4 | 10-18-2001 03:12 AM |
Edelbrock heads? | Coupe Devil | Windsor Power | 7 | 07-18-2001 03:58 PM |
GT-40P heads? any good?? | acidangel316 | Windsor Power | 1 | 07-15-2001 10:26 PM |