Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-20-2003, 01:51 PM
|
#1 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
OK, here it goes. The following link is for the intake, bolts, gaskets, brakets and all you will need to install the new heads for less than $200. The Depot I hope this increases your interest in purchasing my heads. I am spending a pretty penny on new heads from Sean Hyland Moptorsports, and atleast the $500 I am asking for mine will help to offset my cost.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will my exhaust system from 91 gt bolt up to 82 gt? | 4.6l-eatr | Windsor Power | 1 | 02-04-2002 12:08 AM |
| RESULTS - Grand Prix GT vs. Celica GTS | 302 LX Eric | Stang Stories | 7 | 09-25-2001 06:46 PM |
| ran a '01 GT | EZRIDN | Stang Stories | 3 | 08-29-2001 08:17 PM |
| Whooped an '85 GT with my Wife's Volvo | NO SLO PK | Stang Stories | 8 | 07-20-2001 12:46 PM |
| Moroso results w/ stock 207K '87 GT | EZRIDN | Stang Stories | 3 | 07-12-2001 03:58 PM |