Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-24-2003, 04:38 PM
|
#5 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
The first number(888-338-9169) if for engine works. The second number (866-870-0406) is constantly busy. I found the Omega Performance decals and the phone number on them(863-467-3000) is no good. I get the feeling that I am going to have to buy some new rocker arms from a company that actually still exists.
Before I go and do that though, does anyone know if I can get a bolt that will work with the rockers so I dont have have the car totally dead for a year (daycare for the 2 kids is getting to be a killer).
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 289 bent push rod | Emberglo66 | Classic Mustangs | 4 | 04-16-2004 07:06 PM |
| Pushrod Length help | BLACK85GT | Windsor Power | 3 | 02-04-2004 10:27 AM |
| 14.5 on a bent rod | Nixon1 | Windsor Power | 1 | 07-25-2003 05:18 AM |
| Bent a pushrod | Stang951 | Windsor Power | 3 | 06-24-2003 04:45 PM |
| AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |