Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-24-2003, 07:53 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
I called David at CCM today and tried to get info on Omega, but all he could give me was the name off a box he had lying around. Maybe someone else will have better luck with them.
If so please post you results. By the way here are some more pics of mine. I didnt strip the threads in the rocker, but after seeing the damage to the intake rocker and the rest of the threads, I am leary of using them again, even with a new bolt. Threads look ok:  Intake rocker arm    
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 289 bent push rod | Emberglo66 | Classic Mustangs | 4 | 04-16-2004 07:06 PM |
| Pushrod Length help | BLACK85GT | Windsor Power | 3 | 02-04-2004 10:27 AM |
| 14.5 on a bent rod | Nixon1 | Windsor Power | 1 | 07-25-2003 05:18 AM |
| Bent a pushrod | Stang951 | Windsor Power | 3 | 06-24-2003 04:45 PM |
| AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |