MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Clutch help needed!!
Register FAQ Members List Calendar Mark Forums Read

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 06-24-2003, 11:58 PM   #1
RPM427
Registered Member
 
RPM427's Avatar
 
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
Default
I took it all apart, and the bearing retainer, where the throwout bearing slides, was damaged, and was rough. I ordered a steel one from Ford, but what would cause this? What are some causes of the throwout bearing becoming off-center?
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway


-1994 Ranger w/ 427cid windsor (daily beater)
check it out!
RPM427 is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Hybrid Mode Hybrid Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
T-5 swap & cable clutch problem LuvMyStang Classic Mustangs 0 03-19-2003 08:47 AM
Advice needed for a clutch replacement in a 2000 GT GLDNPNY Modular Madness 2 03-06-2003 10:07 AM
Clutch Problems blue302 Windsor Power 3 09-10-2001 01:37 PM
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) beefcake Blue Oval Lounge 2 02-23-2001 03:05 PM
Clutch help needed. 96cobra89Lx306 Modular Madness 1 07-10-2000 09:03 PM


All times are GMT -5. The time now is 06:06 AM.

Archive - Top

SEARCH