How can you tell if Fel-Pro gaskts were installed incorrectly? (hard ?)

Kevin Price · 08-02-2001, 08:33 AM

Itwouldnt surprise me if the head gaskets were on incorrectly but it doesn't sound like you are burning too much water. If a head gasket is on upside down the pattern will ALMOST appear to match, but not quite.

You might be able to pull some plugs to determine exactly what cylinders are burning the water.

In your 69 it wouldn't be a to hard to pull the heads. Before you do that I would pull the valve covers and try retorquing the heads first, especially with aluminum heads.

I tell ya, I just had my motor assembled and my head gaskets were put on upside down, the back of the block was not drilled and NO OIL was getting to my rockers and springs. I had water in my oil and, as a result, I had to send the thing back off, but not to this idiot. Keep in mind this is a VERY expensive motor

What I am saying is these "engine builders" do screw up so I wouldn't rule that out.

------------------
SVO siamesed 351 stroked to 417ci,Yates heads, solid roller,Trans King glide and a little blue bottle
of giggle gas. My Car

[This message has been edited by Kevin Price (edited 08-02-2001).]

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
tremec hard as hell to shift	rob90gt	Windsor Power	16	03-15-2002 02:33 PM
Holley ignition, coil, and distributor installed..car won't start. Any ideas?	chadtn2	Windsor Power	5	08-13-2001 01:13 AM
Replacing convertible top. How hard is it?	Dark_5.0	Windsor Power	7	06-09-2001 09:01 PM
Holy Sh*T, $750 to get a cam installed, just labor.	Shotgun28	Windsor Power	8	01-17-2001 08:18 PM

08-02-2001, 08:33 AM	#5
Kevin Price Registered Member Join Date: Jan 1999 Location: Oxford, KS Posts: 935	Itwouldnt surprise me if the head gaskets were on incorrectly but it doesn't sound like you are burning too much water. If a head gasket is on upside down the pattern will ALMOST appear to match, but not quite. You might be able to pull some plugs to determine exactly what cylinders are burning the water. In your 69 it wouldn't be a to hard to pull the heads. Before you do that I would pull the valve covers and try retorquing the heads first, especially with aluminum heads. I tell ya, I just had my motor assembled and my head gaskets were put on upside down, the back of the block was not drilled and NO OIL was getting to my rockers and springs. I had water in my oil and, as a result, I had to send the thing back off, but not to this idiot. Keep in mind this is a VERY expensive motor What I am saying is these "engine builders" do screw up so I wouldn't rule that out. ------------------ SVO siamesed 351 stroked to 417ci,Yates heads, solid roller,Trans King glide and a little blue bottle of giggle gas. My Car [This message has been edited by Kevin Price (edited 08-02-2001).]