

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#9 |
My poor 79 RIP
Join Date: Oct 2001
Location: Suisun City,
Posts: 2,320
|
![]() I would more lean to the conetions to the block. U may be running a connetion that is fine when cold, but when those wire heat up, as I've noticed, they seem to lose power, more restaince some how. Before u go and buy another starter, save some money by either cleaning your connections, or buying some 2-4 guage wires. Make sure they have good, clean points.
I was having the same ploblem with my car a couple of weeks ago, and i thought I trouble shot it down to a bad starter. When it was cold, everything was fine, but after it was warm, it seemed like the starter was taking too much juice out of the battery. I tried one last thing before going to get the stater, and it fixed it. I found out that my battery connections were lose, but not bad enough to see or cause any thing else. They were only lose by a little bit, but it was enough to cause a hard crank when it was warm. So now it works like new. So, here;s what I'd do #1 check batt connections #2 check ground, then power connections #3 buy bigger 2-4 guage power and ground wires If nothing else, then #4 buy a new, not rebuilt starter.
__________________
'84 mustang GT turbo '85 LTD '89 Camaro Irocz z28 '94 Lightning '96 Trans am |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
'94 Ford Bronco starting problems | Simi Stang | Built Ford Tough | 5 | 01-17-2003 08:53 PM |
problems starting car, please help | apowers2k | Modular Madness | 1 | 11-08-2002 12:17 PM |
Problems with starting and acceleration | 7up | Windsor Power | 5 | 04-15-2002 11:08 PM |
starting problems on a new 306 w/eecIV | fordplay | Windsor Power | 6 | 03-16-2002 01:06 PM |
starting problems | 92Convertible | Windsor Power | 1 | 03-10-2002 06:22 PM |