Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-30-2003, 03:41 PM
|
#2 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
It seems like your rear springs are a bit soft at 300 lb/in. If they are in the stock location, I would think that with the torque arm and the 1000 lb/in front springs that you would be getting understeer. Most folks recommend closer to 350 or 400 lb/in for that type of setup so that the rear will take on more cornering load.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Handling set-up | polara7777 | Corner Carvers Delight | 3 | 05-13-2002 11:49 AM |
| gas millage and handling question | Cataract2 | Blue Oval Lounge | 7 | 04-17-2002 10:02 PM |
| Best Handling Early Mustang? | bigcarguy | Classic Mustangs | 6 | 12-29-2001 08:33 PM |
| Handling | Black02GT | Modular Madness | 5 | 11-28-2001 02:46 AM |
| handling | yusuf | Classic Mustangs | 8 | 06-12-2001 03:51 PM |