Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-30-2003, 07:13 PM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Charlotte NC
Posts: 193
|
OK, through unemployment and tough times I am finally around to putting these springs on. I have got the spring compressed with the top of the spring compressor using the top of the spring tower for support. ( as shown in my haynes manual) I am trying to follow my Haynes manual but don't know what to do when it says, "remove the 2 upper arm to spring tower attaching nuts and swing the upper arm outward from the spring tower" That is the last step before spring removal. I'm not sure what 2 nuts they are talking about. I know it's probably a pain to describe but any help would be appreciated. Thanks.
__________________
1969 fast back; yellow; weld wheels; 302 roller with GT-40 heads; 3:55 gears; 5spd T-5; MSD 6AL; E-303; flows; Hedman headers; Holley 600;Weiand Accelerator;1.6 rockers |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cut front coil springs? | 420nitro | Windsor Power | 13 | 01-26-2004 07:54 PM |
| Are the front or back springs shorter? | Bad89stang | Windsor Power | 2 | 08-05-2002 11:35 AM |
| front springs | greydan | Windsor Power | 3 | 06-27-2002 11:23 PM |
| needing the best front and rear drag springs | Mustangboy89 | Windsor Power | 3 | 09-21-2001 01:30 PM |
| front springs | 69fastback | Classic Mustangs | 1 | 02-26-2001 11:11 PM |