Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-03-2003, 06:32 PM
|
#15 |
|
Registered Member
Join Date: Nov 2002
Posts: 23
|
You didn't, by chance, happen to take a pic of your messed of balancer did you? I'd like to see one.
I checked my balancer when I had everything off and it wasn't that bad. Very minor hairline cracks and stuff like that in it...but it didn't seem like anything serious. Then again, I dont have any vibration issues at low or high speed. Just curious...how did you get it off? Impact wrench? I wedged a wrench between the balancer and a bolt on the engine block. Very crude...but it worked! (I did the same to get it back on, too...) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help with water pump install | jkoral | Windsor Power | 12 | 09-02-2004 04:21 PM |
| Water pump install... | Bad89stang | Windsor Power | 3 | 01-19-2003 10:59 AM |
| STEWART Water Pump issues :( ?? | LOBE_50 | Windsor Power | 6 | 05-15-2002 08:34 AM |
| Water pump....AC Bracket problem | Jimmy Page | Classic Mustangs | 3 | 07-28-2001 01:54 PM |
| Pulleys, water pump, and fan clutch | dinomite | Windsor Power | 5 | 05-26-2001 09:00 AM |