Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-04-2003, 05:26 PM
|
#1 |
|
Registered Member
Join Date: Feb 1999
Location: Caracas, Venezuela
Posts: 81
|
I think I've found a 1 3/8" front bar, would check bar installation and bushings (already has energy bushings), will make more clearance in the stru tower to get more caster, then meter bump steer to check.
But I don't know where I might get a stiffer rear anti sway bar that could get fit cause I've already has the torque arm and panhard bar and after market chassis fitted bars like hotchkis or steeda extra won't fit (I assume), any ideas?
__________________
92GT, SOLO RACER, COBRA BRAKES, R1 TIRES, GT40, GT40X HEADS 58CC, 24LBS, 70MM/65MM, E303, MAC 1"5/8 LT HEADERS, 3" XPIPE AND EXHAUST W/CUT OFFS, 4.10, H&R 950-1050 SPRINGS, BILSTEIN SHOCKS, MM PANHARD AND TA, MANY ROAD RACE MODS, CORVETTE, CAMARO, RX7 AND SUPRA SOLO EVENT EATER www.killersracing.com www.clubcopa.com 
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Handling set-up | polara7777 | Corner Carvers Delight | 3 | 05-13-2002 11:49 AM |
| gas millage and handling question | Cataract2 | Blue Oval Lounge | 7 | 04-17-2002 10:02 PM |
| Best Handling Early Mustang? | bigcarguy | Classic Mustangs | 6 | 12-29-2001 08:33 PM |
| Handling | Black02GT | Modular Madness | 5 | 11-28-2001 02:46 AM |
| handling | yusuf | Classic Mustangs | 8 | 06-12-2001 03:51 PM |