Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2001, 10:25 AM
|
#2 |
|
Registered Member
Join Date: Jan 2001
Location: Rochester Hills, MI
Posts: 40
|
If the valves aren't worn I'd just clean them up a bit, if they are I'd got witha low end set of Manley valves. As far as springs go you could go with a dual spring setup for a bit more open/close pressure. What cam are you running? If stock go ahead with 1.7's they'll give you .33(.477) lift, and be a bit more agressive, with no interference.
Just buy a set of Ford Mtrsprt pushrods for you application. Rob |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud knock after head rebuild | Hozer 88GTConv | Windsor Power | 9 | 03-12-2004 11:21 PM |
| T-5 Rebuild | 95/GT/5.0 | Windsor Power | 9 | 12-26-2002 10:23 PM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head Rebuild ? | mike5p01 | Windsor Power | 0 | 09-09-2001 12:05 PM |