Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-14-2003, 11:05 AM
|
#8 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
To plug the heads you can go to the hardware store and find a bolt about 3/4 of an inch long that is the right size and threads and use that. The hole is threaded. It's a standard size. Find someone's old set of heads and clean out the hole and see for yourself, just find a bolt that will fit it.
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| smog pump delete | 89droptop | Windsor Power | 11 | 03-15-2010 04:01 PM |
| Smog Pump Confusion | Evil Joe | Windsor Power | 1 | 03-23-2003 08:04 AM |
| SN95 Smog Pump Drama | Mustangbelle306 | Windsor Power | 5 | 02-27-2002 01:02 AM |
| PLEASE HELP!! Do I need the smog pump system to pass dyno emissions ?? | Stang_ROTY | Windsor Power | 5 | 07-02-2001 01:09 AM |
| Cats but No Smog Pump | KobraLX | Windsor Power | 11 | 03-20-2001 09:30 AM |