Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-18-2003, 01:19 PM
|
#1 |
|
Registered Member
Join Date: Mar 2003
Posts: 32
|
I might not have explained well enough. The 2.02 valves were referring to aftermarket heads. I know that if you go bigger you take away from the bottom end and more for top end, and I rev up to 5500-6200rpm and let off. So I think the stock valves are 1.76 int and 1.54 exhaust maybe, correct me if i'm wrong.
I might be also messing up with the fabbed sheet metal upper but we'll see. While the base is a truck lower. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| Cylinder Head Swap | Fostang | Windsor Power | 0 | 05-05-2001 09:51 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |