Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-31-2003, 01:47 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Citrus Heights, CA
Posts: 74
|
I have a '81 Toyota truck (it's my wheeler) and I had the same problem that you have. My problem was a vacuum line totally fell off of the carb. I can't remember exactly where it was connected to, and I am at work right now, but when I get home tonight I will try to figure out exactly where it was. I don't know if this will help you other than it is a good possibility that it is a vacuum leak (hopefully). Take a piece of vacuum hose and listen through it at different places on your motor to see if you can hear anything.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| High idle | Hethj7 | Windsor Power | 7 | 08-04-2004 05:45 PM |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Idle too high, Popping thru intake still . . . | SheStang87 | Windsor Power | 3 | 06-23-2003 10:32 PM |
| Still Am a high Idle...... | Stang Runner | Windsor Power | 3 | 05-06-2002 04:23 PM |
| Idle too high after TB install... | Bad89stang | Windsor Power | 18 | 04-24-2002 09:41 PM |