Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-31-2003, 11:30 PM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: Lynwood, CA, U.S.A.
Posts: 82
|
I knew that was the "nut" that you were talking about. My last question is this: Do you think that not milling the pedestals is ok? I mean, if I can get away with using longer push rods, I'd rather do that. I really haven't checked how much that would cost me, but just in case, I wouldn't mind saving a few dollars if possible.
__________________
65 Mustang Coupe...Comp Cams 262 Xtreme Energy, T-5 conversion, Romac Balancer, 620 Front Springs-4.5 Mid-eye rear springs.......work in progress |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker Arm Stud Removal | sleeperstang | Windsor Power | 1 | 08-02-2003 02:10 PM |
| adjusting valves/ stud mount?? PKRWUD? Anyone?? | Simi Stang | Windsor Power | 8 | 07-08-2003 11:43 AM |
| TFS TW rocker stud Q | drudis | Windsor Power | 0 | 01-22-2002 02:37 PM |
| Adjustable roller rocker problems | Greystang302 | Windsor Power | 0 | 05-14-2001 01:57 PM |
| stud mount rocker install | Blown 306 | Windsor Power | 2 | 05-13-2001 10:25 AM |