

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#4 |
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
![]() while they are fixing the rear end put in a set of 3:73 gears. No HP gain but it is the best Mod for the buck ( you can feel the difference ). The K&N is nominal HP and the pullies are no problemo! still minimal HP gain. Number one rule " DO NOT BELIEVE THE ADDS WHEN THEY STATE HP GAINS ! ! ! " Read the FAQ's and folllow the site and learn before you go mod happy. It will set you on the right path. There are too many ways to go and depending on budget you have to chose your own way of getting there. MY own opinion is, Gears, Exhaust( X/H and cat back) , pullies, chip, K&N somewhere in between all those, by then you will want a better car. The 98's are good starter cars but cost much more to get the extra HP than the 99 up with the PI heads.
Good luck and welcome!
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
speedy density to mass air questions | thdrcat | Windsor Power | 3 | 09-25-2003 09:20 PM |
Quick questions on Explorer Intake install. | Falcons Talon | Windsor Power | 2 | 08-21-2003 12:40 PM |
Several questions about oil. | zepherman | Windsor Power | 3 | 08-03-2002 06:59 AM |
HELP! Newbie 95-96 GT questions | Ron Brooks | Blue Oval Lounge | 7 | 07-11-2001 07:38 PM |
S/R Questions | DAMION | Racer's Club House | 1 | 09-30-1999 11:02 AM |