Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-03-2003, 06:45 AM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
We just did that on my friends (my old car) 86 GT, I'm pretty sure I've done it a few times before also. When I was putting my motor together last week I figured I'd leave the oil pump shaft out until for a while so it wouldn't fall out everytime I turned the engine upside down, but luckily I looked at the shaft and realized it needed to go in first before I put the oil pan on and put it in the car, that would have been a b*tch to get in then.
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help I need heads!! | SmokinStangGT | Windsor Power | 18 | 05-04-2003 10:05 PM |
| New FRP Heads for 96 - 98 4.6 | surfbeast | Modular Madness | 9 | 11-21-2002 07:02 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |