Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-10-2001, 01:47 PM
|
#3 |
|
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
Mine clears my MAC tailpipes, I just bouight some heat shielding sleeves and covered the lines to make sure the tailpipe doesn't burn it.
------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| brake lines, help! | mustangman65_79 | Windsor Power | 10 | 06-30-2002 10:37 PM |
| Stainless steel braided brake lines | Radon | Windsor Power | 20 | 03-24-2002 01:08 AM |
| Disk Brake Coversion - bending brake lines | glxstang | Windsor Power | 1 | 11-03-2001 11:23 PM |
| Flaring Brake Lines | glxstang | Windsor Power | 3 | 10-28-2001 11:51 AM |
| SS front brake lines for M2300K | drudis | Corner Carvers Delight | 1 | 04-11-2001 12:57 PM |