Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-11-2003, 09:05 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
Mine are a mess, they sound like sh*t and I can't get them to run quiet. They're stud mount roller rockers (proform/blue 1.5 ratio) and I just rebuilt the motor with a new set of Crane blazer pushrods, I'm also running a high volume oil pump which keeps the pressure up plenty even when it's hot. I've tried adjusting them with 1/2 turn then I tried a little more, then 3/4 turn and they almost seem worse. I'd think they'd get quieter and eventually the motor would run crappy if they were too tight, but they wouldn't be noisey. Any ideas??
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor back together - strange noise???? | DZEE'S LX | Windsor Power | 13 | 03-15-2002 12:46 AM |
| roller rocker noise! | Chevysucks | Windsor Power | 18 | 11-28-2001 09:58 AM |
| Rear end Noise or Tranny Noise??? | jz_mustang50 | Windsor Power | 0 | 10-02-2001 05:21 PM |
| roller rocker noise..? | PrplMonster | Windsor Power | 3 | 08-09-2001 07:35 PM |
| Air Intake Whistling Noise?! | sgrn | Modular Madness | 4 | 10-25-2000 09:46 AM |