

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Jul 2001
Location: Edison, NJ, USA
Posts: 125
|
![]() I agree with canukracer except I say replace the whole rack anyway, easier than doing the inners. That loose tie rod has been beating away at the rack, no sense keeping it if it's probably going to go bad later anyway.
From NAPA Online you can get a reman. rack with tie rods and inner rod ends for about $87. Add another $30 for outers and your set. I went almost all out when I did mine and got a PS pump and aluminum bushings from Maximum Motorsports. I kept the hoses (should have replaced them) and already had relatively new outers so I didn't bother with them. Good luck, Rich D. |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power steering rack | bigred90gt | Windsor Power | 1 | 11-09-2002 10:22 PM |
Rack & Pinion or Stock steering for '67 | Yellow67GTA | Classic Mustangs | 0 | 09-30-2002 10:04 PM |
Steering rack replacement questions. | chris91LX | Windsor Power | 2 | 09-04-2002 11:39 AM |
Steering rack blew | chris91LX | Windsor Power | 4 | 08-26-2002 09:25 AM |
Power Steering rack is TOAST!?!?! | Mustangbelle306 | Windsor Power | 9 | 03-28-2002 02:55 AM |