hey simi!

09-22-2003, 03:14 PM

Hey Jim, sorry to hear you are having problems. When you mention "adjust the allen screw in the back of it"...did you mean the back of the Hobbs switch? If it was once set correctly than I really don't think it needs further adjusting. You are not talking about setting your fuel pressure with the adjustable fuel pressure regulator are you? I have a NOS kit #5115 and my Hobbs switch does not have an allen bolt in the back of it...so you may have something different?? If the system works when crossing the two wires than the Hobbs switch could be your problem...or your fuel system isn't pushing enough fuel volume to withstand the adequate amount of fuel pressure required when the nitrous is being used. What level of shot are you currently running? Still just the 75hp. or have you gotten the itch to bump it up to a 100 or 125 shot yet? Because your problem might not Hobbs switch...you may not have adequate fuel pressure when using the nitrous...and your Hobbs switch is doing it's job and cutting off the flow of nitrous. You may need to get an additional inline fuel pump such as the T-Rex or something similar. I run a 155lph intank pump...and a 200gph MSD inline pump and have no fuel volume/psi. problems. Let me know if that helped any...we'll figure this bug out.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with my motor. Any ideas would help me -5.0 power-	T5superduty	Windsor Power	28	10-03-2003 02:17 PM
hey simi!	1jimmy__d	Power Adders	3	07-21-2003 05:15 PM
simi?	1jimmy__d	Windsor Power	1	07-07-2003 05:50 PM
wheres SIMI STANG	sn95gt19	Blue Oval Lounge	1	06-02-2003 11:22 AM

09-22-2003, 03:14 PM	#2
Simi Stang Guest Posts: n/a	Hey Jim, sorry to hear you are having problems. When you mention "adjust the allen screw in the back of it"...did you mean the back of the Hobbs switch? If it was once set correctly than I really don't think it needs further adjusting. You are not talking about setting your fuel pressure with the adjustable fuel pressure regulator are you? I have a NOS kit #5115 and my Hobbs switch does not have an allen bolt in the back of it...so you may have something different?? If the system works when crossing the two wires than the Hobbs switch could be your problem...or your fuel system isn't pushing enough fuel volume to withstand the adequate amount of fuel pressure required when the nitrous is being used. What level of shot are you currently running? Still just the 75hp. or have you gotten the itch to bump it up to a 100 or 125 shot yet? Because your problem might not Hobbs switch...you may not have adequate fuel pressure when using the nitrous...and your Hobbs switch is doing it's job and cutting off the flow of nitrous. You may need to get an additional inline fuel pump such as the T-Rex or something similar. I run a 155lph intank pump...and a 200gph MSD inline pump and have no fuel volume/psi. problems. Let me know if that helped any...we'll figure this bug out.