Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-26-2003, 10:09 PM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
Man, never seen that happen before, but there's a first time for everything. The valves can collide with pistons for numerous reasons. One is a sloppy valve train where at high rpms the slop basically gets magnified. Anyway, could have been something else that caused the motor to go too. Good luck man.
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| upper and lower intake manifold | V 8's 4 life | Stang Stories | 2 | 12-11-2003 04:35 PM |
| Ported and polished intake manifold? | 98GtPower | Modular Madness | 1 | 09-01-2002 06:27 PM |
| Trick flow 351W efi intake | Strim91GT | Windsor Power | 0 | 02-18-2002 01:53 PM |
| Check this out: prototype 5.0 intake manifold??? | Dark_5.0 | Windsor Power | 2 | 02-17-2002 10:50 AM |
| will a intake on a 5.0Lefi fit on a 351w | aonick | Windsor Power | 4 | 09-18-2001 09:46 AM |