Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-14-2001, 03:29 AM
|
#6 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
What are you talking about - sub frames? Are you talking about sub frame connectors? Or are you talking about the actual frame of the car? Please clarify. Take pics if you have to!
As for the motor mounts (it's really an engine, not a motor  ), go with Energy Suspensions poly mounts for the engine and tranny. I bought the convert mounts and really wish I had gone with Energy Suspension stuff, although the convert mounts are fine. I'm not sure if the convert mounts sit the engine higher or not, they did raise mine a little (90LX 5.0), but my mounts were shot so the engine was probably sagging to begin with.Email me when you reply to this Big Bopper so I can see what you are talking about in regards to the subframes ------------------ Gunning for 12's!  Buy your parts here ICQ# 42269241 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| K frames, whose is best for Street and Drags? | Idhomustang | Windsor Power | 3 | 01-06-2003 12:43 AM |
| Cooling Guru Needed !! | Evil Joe | Windsor Power | 7 | 11-23-2002 01:56 PM |
| Exactly whats needed for install of o/r?? | Stang39r | Windsor Power | 3 | 05-01-2002 02:19 AM |
| What's needed to build a Turbo 5.0L? | Gautam | Windsor Power | 1 | 06-07-2001 05:34 PM |