Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-31-2003, 11:01 PM
|
#1 |
|
Import Slayer
Join Date: May 1999
Posts: 2,241
|
The TFI modules were notorious for going bad in Fords.
One of the signs of it going bad is the car stalling and not starting until the module cools off again. Yes, replace the original module if you still have it. That's what I'm going to do. Keep the old one as a spare so you have one if the new one goes someday. That way, your're not left stranded somewhere. I'm not sure if there is a difference between the Ford replacement or aftermarket units.
__________________
'82 GT 351W (.060)Comp Cams 274* Extreme Energy cam, ported & polished heads w/ 1.94/1.60 valves 10.3:1 flat top pistons,stealth intake, Mallory dizzy,Holley 750dp carb, BBK shorties,Flowmaster exhaust,C-4 with 3700 stall converter, B&M pro shifter,8.8 rear, 4:10's, subframes, electric fan, powermaster alternator, 4 core radiator. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ball joint replace in a 65 - how hard is it? | Steriti | Classic Mustangs | 5 | 07-03-2004 05:32 PM |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Fuel Pump or TFI Module ??? | mimicons | Windsor Power | 1 | 05-13-2003 02:35 AM |
| Is it hard to replace coil springs? Should I pay? | jpumpkinn | Windsor Power | 3 | 06-27-2001 11:46 AM |
| 8" Traction-lock clutches...how hard to replace | Rev | Windsor Power | 2 | 02-11-2001 06:03 PM |