Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-21-2003, 09:55 AM
|
#2 |
|
Registered Member
Join Date: Oct 2003
Location: Enterprise, AL
Posts: 26
|
The only way that I know of to reduce weight other than the obvious (remove spare ,tire back seat, ect) is to get a tubular K-member, A arms, and coil overs, which will shave about 100lbs off, but it will cost about 1k. I would look at super chargers, I have been look at them for mine, and have found that the Kenne Bell, 6psi set up is nice. It will bolt right on with no modifications, go right where your GT40 upper goes, put on a longer belt and your done. It is worth about 115 HP and 120 Torque. Go to www.kennebell.net . Then find a place to get a custom chip burnt and you won't have a problem with ricers anymore.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| thinki saw '93 cobra but not sure.....plz confirm this for me(description) | yelowjaket | Blue Oval Lounge | 5 | 06-09-2003 05:49 PM |
| Please Comment of Speed Secret # 2 | jim_howard_pdx | Windsor Power | 20 | 11-06-2002 11:44 AM |
| Cobra Computer | Bangin Gears | Windsor Power | 1 | 04-30-2001 02:38 AM |
| Safety Recall for 1999 Cobra and 2000 Cobra R | JoeJ | Special Production | 0 | 04-13-2001 08:18 PM |