Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-03-2003, 11:25 AM
|
#1 |
|
Registered Member
Join Date: Nov 2003
Location: SC
Posts: 7
|
The 393 will make awesome, streetable power. The 351 with the blower will to, but will need more tuning. I say a 10.5:1 comp., custom hyd. roller cam, and stg1 Vic Jr's would be a awesome set-up. The motor will need a good intake, 75mm t-body, and the right fuel system. This should easily put 450-475rwhp down with a manual trans., and be mid-low 11's.
Later, Greg(XSR)
__________________
www.xsrcylinderheads.com 86Gt with stroked 351W, XSR Vic Jr heads, XSR super Vic int, XSR custom solid roller cam, MM C-4, TCT 8", NOS Bigshot, Moser race 33s axles, spool, etc...... 6.49@107 w/1.43 60ft(NA) 6.01@118 w/1.39 60ft(225 shot) |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| blew a head gasket on a '93 sable | st5150 | Small Ponies | 0 | 03-21-2000 09:43 PM |