Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
12-07-2003, 03:10 PM
|
#3 |
|
Registered Member
Join Date: Jul 2002
Location: Michigan
Posts: 417
|
I wish I could have got longtubes too but when I first got the car I just had to make it loud so I put flows and a bbk h-pipe on as fast as I could and if I were to go longtubes I'd have to dish out for longtubes and a new mid-pipe but shorties are better then the stock being stock exhaust ports share that whole long tube so might as well being I got a very good deal on these headers and maybe a smoother exhaust note......
__________________
1996 Mustang GT, AODE -Trickflow Upper Plenum -BBK 70mm Throttlebody -02 PI Lower Intake -March Pulleys -BBK H-Pipe -2 Chamber Flowmaster mufflers -3000 RPM Stall -JLT CAI with special K&N -MSD Supercondutor wires -180 stat -FRPP 4:10's *FOR SALE C&L TRUE FLOW INLET PIPE WITH K&N* My Stang |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Question for 94-95 owners concerning 1.7RR INSTALL | SlowStang2 | Windsor Power | 6 | 09-22-2001 06:39 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |
| Roller Rocker install questions. (long) | chris91LX | Windsor Power | 5 | 03-15-2001 09:32 PM |
| Header Install | DemonGT | Windsor Power | 3 | 03-08-2001 04:11 PM |
| check engine light after long tube install | tomazzzo | Windsor Power | 8 | 02-19-2001 05:49 PM |