Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2001, 03:34 PM
|
#5 |
|
Moderator
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
|
Actually, the size corresponds with the OD of hard tubing. -8AN is 1/2 inch tubing, whether its 0.035" wall, 0.065" wall or any other wall. With flex lines, it really doesn't correspond with anything other than a nominal hose/line size. A -8 braided hose has neither a .500" ID nor a .500" OD, but its OD is in the general neighborhood of 1/2 inch.
------------------ Jeff Chambers Trophy Stock #3 11.97 Seconds / 114.5 MPH Chambers Racing Team |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Grease Question | Kisner | Classic Mustangs | 9 | 03-16-2004 07:47 PM |
| creaking noise!! AHH! | 89GTimporteater | Windsor Power | 4 | 03-20-2003 06:49 PM |
| What fittings will i need? | mustangLX92 | Windsor Power | 0 | 07-02-2002 07:33 AM |
| Teflon tape with nitrous fittings | Radon | Windsor Power | 4 | 04-05-2002 01:04 AM |
| Oil Leak from S-Trim fittings...HELP | quick89gt | Windsor Power | 0 | 08-03-2001 03:44 PM |