MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page changing thermostat
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 08-18-2001, 02:09 AM   #3
BlackFly
Registered Member
 
Join Date: Feb 2001
Location: winnipeg , manitoba , canada
Posts: 83
Post
put the thermostat into the housing and silicone the gasket on and let it dry for about 10 min..this should allow you to get it into place before it falls out.
BlackFly is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
98 intake and thermostat AutoX281 Modular Madness 3 09-26-2003 07:51 PM
changing a rear end ragtop5point0 Windsor Power 7 02-06-2003 01:37 PM
Thermostat & Cooling System GhettoPop Windsor Power 4 01-20-2003 07:54 PM
Thermostat 160* or 180*?? NewStang02 Small Ponies 3 07-02-2002 10:26 AM
Changing ring & pinion gear is illegal Ripper Modular Madness 1 04-06-2000 12:45 PM


All times are GMT -5. The time now is 09:58 AM.

Archive - Top

SEARCH