Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-13-2004, 01:17 PM
|
#1 |
|
Registered Member
Join Date: Aug 2000
Location: Plymouth, MI
Posts: 254
|
block machining
The Dart blocks are line honed already. Decks are within .005". Cylinder bores are left .010" under for finish honing. The lifter bores are finished to within .001". Due to the variety of lifters, you may have to touch up the lifter bores depending on lifter choice. OEM hydraulic rollers will not fit without machining. Crane drop-in lifters are the easiest route. Early blocks were not drilled for the spider, although that is now performed on newer blocks.
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W sportsman block bore ?? | 84GT350-1 | Windsor Power | 0 | 02-07-2004 08:18 AM |
| Rebuild HiPo 289 using M-6010-B50 Sportsman block | skidado | Classic Mustangs | 3 | 10-18-2003 01:52 PM |
| Which 351w block should I look for? | BLACK85GT | Windsor Power | 12 | 12-03-2002 10:00 AM |
| More Sportsman 351 block questions? | novi408 | Windsor Power | 1 | 03-20-2001 09:09 PM |
| Can you take a Sportsman 351 block to .040 over? | novi408 | Windsor Power | 3 | 03-16-2001 10:22 PM |